Sharp VE-CG40U Service Manual download pdf (Page 7)

VE-CG30U

VE-CG40U

Disconnect the two connectors to take out the CCD

PWB.

Each connector has four wires.

(For 40U, disconnect the three connectors.)

Remove the one screw ((b)LX-HZ0050TAFF) and

disconnect the connector to take out the top cabinet.

8. Remove the four screws ((f)XiPSF17P03000)

to take out the AV jack PWB and strobe unit.

Caution:

Hold the transformer to remove the strobe unit.

CCD PWB

Connector(CG40U only)

Connector

AV jack PWB

Strobe unit

Transformer

Prepare approx. 5kΩ/5W.

Figure 1

Clip

High voltage section

Clip connection

Caution: Electric shock

When disassembling or repairing the set, do not touch the high voltage section of the main capacitor

since it contains high voltage. Be especially careful when removing and mounting the screws of the jack

unit (DUNTKB359PM) and strobe unit as well as when replacing the wires (QCNW-A562/564/565WJ).

After removing the strobe unit, prepare the following discharging jig (1) and connect it to the (2) position

as shown in the figure. Discharge main capacitor by leaving discharge jig attached for 60 seconds.

1 2 3 4 5 6 7 8 9 10 11 12 ... 66 67

No comments

Sharp VE-CG40U Service Manual Page 7