Sharp XL-DK227N Operations Instructions download pdf (Page 11)

03/12/17 XL-DK227N.fm

XL-DK227N

Preparation for Use



Antenna connection

Supplied FM antenna:

Connect the FM antenna wire to the FM 75 OHMS jack and position

the FM antenna wire in the direction where the strongest signal can

be received.

Supplied AM loop antenna:

Connect the AM loop antenna to the AM and GND terminals. Position

the AM loop antenna for optimum reception. Place the AM loop

antenna on

a shelf, etc., or attach it to a stand or a wall with screws

(not supplied).

Note:

Placing the antenna on the unit or near the AC power cord may

cause noise pickup. Place the antenna away from the unit for better

reception.

Installing the AM loop antenna:



Speaker connection

Connect the black wire to the minus (–) terminal, and the red wire to

the plus (+) terminal.

Caution:



Connecting

iPod

to a TV

The iPod with photo and video can be viewed by connecting to a TV/

monitor.

If the TV/monitor has a video input, connect it to the VIDEO OUT jack

on the rear of the unit.

Note:

Please make sure to set iPod unit to either NTSC or PAL to match your

TV signal. Please visit Apple’s home page for futher information.

< Assembling > < Attaching to the wall >

Wall Screws (not supplied)



Use speakers with an impedance of 4 ohms or more, as lower

impedance speakers can damage the unit.



Do not mistake the right and the left

channels. The right speaker is the one on the

right side when you face the unit.



Do not let the bare speaker wires touch

each other.



Do not allow any objects to fall into or to be

placed in the bass reflex ducts.



Do not stand or sit on the speakers. You may

be injured.

Red Black

Incorrect

To video

input jack

Video cable

(not supplied)

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 35 36

Comments to this Manuals

No comments

Sharp XL-DK227N Operations Instructions Page 11

Comments to this Manuals

Related products and manuals for Audio tuners Sharp XL-DK227N