Sharp FP-N60CX User Manual download pdf (Page 17)

ENGLISH

Plasmacluster

AUTO

MANUAL

Fan Control

POLLEN

OFF

TIMER

DISPLAY

ON/OFF

POWER ON/OFF

FILTER RESET

CLEAN

ION CONTROL

OFF

AUTO

E-15

REMOTE CONTROL OPERATION

Operations available with

the Remote Control

• AUTO

• MANUAL

• POLLEN

• OFF TIMER

• DISPLAY ON/OFF

Plasmacluster ion mode

selections

• AUTO

• CLEAN

• ION CONTROL

• OFF

• When you press the POWER ON/OFF Button, a short beep will

sound and operation will start. As the initial operation mode, it

automatically goes to the AUTO (Fan level) and AUTO

Plasmacluster ion Mode.

•To stop operation, press the POWER ON/OFF Button again.

A long beep will sound and operation will stop.

POWER ON/OFF Button

Used to start AUTO operation

of the unit. A short beep will

signal that the unit is on and

a long beep means that the

unit is off.

Auto (Fan Level) Button

The fan level switches auto-

matically depending on the

amount of impurities in the air.

Manual (Fan Level) Button

The fan level can be switched

between Silent, Medium, High

and Max.

Display ON/OFF Button

Switches the Plasmacluster

Indicator Light and CLEAN-

SIGN Light either ON or OFF.

• The Plasmacluster Indicator

Light is turned on for about

3 seconds by pressing the

Plasmacluster Ion Select

Button (except for the OFF

Button) during “Display

OFF” mode.

Transmitter

Filter Reset Button

When you have cleaned the

Washable Active Carbon Filter

and re-inserted into the main

unit, press the Filter Reset But-

ton with an instrument with a

point such as a pen.

Pollen Mode Operation Button

The unit operates effectively

when you suspect there is pol-

len in the air. See Page E-14

Off Timer Button

Used to set the Off Timer.

The set time switches every time

the button is pressed as shown

below.

1 hour 4 hours

Cancel 8 hours

• The indicator light shows the re-

maining time.

• The unit will cease operating

when the timer is up.

Plasmacluster Ion mode Selections

Auto

When pressed, the unit will switch between

Clean Mode and the Ion Control Mode auto-

matically depending on the amount of impuri-

ties in the air as detected by the dust and odor

sensors. Clean Mode will operate for about 1

minute when the Auto function is selected.

Ion Control

When pressed, the unit will constantly oper-

ate in Ion Control Mode.

Ion balance is maintained in the room envi-

ronment by increasing the ratio of negative

ions. (The Plasmacluster Indicator Light is

green)

Clean

When pressed, the unit will con-

stantly operate in the Clean Mode,

in which the same numbers of posi-

tive and negative ions are dis-

charged. (The Plasmacluster Indi-

cator Light is blue.)

Off

The generation of ions will cease

and the Plasmacluster Indicator

Light will go out.

If the room is damp or has a mold problem, operate the unit in Clean Mode.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 47 48

Comments to this Manuals

No comments

Sharp FP-N60CX User Manual Page 17

Comments to this Manuals

Related products and manuals for Air purifiers Sharp FP-N60CX